MSI Everlife Kallum Fauna

MS001 Universal Pressure Sensitive LVT Adhesive is and ultra-low odor, zero calculated VOC adhesive with aggressive tack properties. This light-colored, solvent-free adhesive is made in the USA and contains and antimicrobial system for enhanced resistance to mold and mildew. When used with Vinyl Floor Tile, it provides a tenacious, permanent bond that’s approved for residential and light-commercial environments. This is a 4 gallon pail and each gallon covers approximately 220-260 square feet.

Adhesive/Cutback Sealer a 4 gallon bucket. Each gallon covers approximately 315-360 square feet. This light-colored, high-strength acrylic polymer compound is solvent-free and contains and antimicrobial system for enhanced resistance to mold and mildew.

This acrylic floor preparation Concrete & Floor Primer solution is designed to improve flooring substrates for a better bonding surface before the application of a floor-covering adhesive for installing Vinyl Floor Tile. MSI’s MS003 is suitable for a variety of substrates and can help prevent over absorption of adhesives— resulting in a better bond. Offering zero calculated VOC’s and ultra-low odor, it’s and ideal water-based primer designed and warranted for use only in conjunction with MSI adhesives. This is a 4 gallon pail, each gallon covers approximately 350-400 square feet with 3/8" nap roller and 400-500 square feet with sprayer application.

MS001 Universal Pressure Sensitive LVT Adhesive is and ultra-low odor, zero calculated VOC adhesive with aggressive tack properties. This light-colored, solvent-free adhesive is made in the USA and contains and antimicrobial system for enhanced resistance to mold and mildew. When used with Vinyl Floor Tile, it provides a tenacious, permanent bond that’s approved for residential and light-commercial environments. This is a 1 gallon pail and each gallon covers approximately 220-260 square feet.

94" end caps (also called baby threshold or square nose) are used to fill the gap between the floor and carpet, hearths or against sliding doors. 1.5" x .25" x 94".

94" flush stair noses (also called bullnose) are used to finish the end of a step. 2.75" x .75" x 94".

94" surface reducers are used to fill the gap between floors of unequal heights. 1.77" x .345" x 94".

94" quarter round are used against cabinets, sometimes against baseboards if you choose to not remove them, and sometimes against other flat vertical surfaces such as some thresholds. 0.64" x 0.75” x 94".

94" Overlap Stairnose, sometimes referred as a bullnose. Used on the outside corner of a stair or step down to finish/trim out the wood, laminate, or vinyl between the riser and the tread. 2.23" x 1.03” x 94".

2-pack, 47.25" stair tread eased edge is used to fully cover the top layer for each stair, eliminating the need for stair nosing. 12" x 1.25” x 47.25".

94" t molding are generally used to transition between wood/wood-like and tile floors, sometimes it is used to transition between and existing wood floor as well, or maybe any surface close in height to the new wood/wood-like floor. 1.77" x 0.28” x 94".